| Quantity: | |
|---|---|
LC105
Lincoln
The power supply must be cleaned as often as necessary to prevent the accumulation of metallic dust inside the unit. See Section 2 for unit dimensions.
Manual Gas Console (MGC)
The MGC should be mounted near the CNC controller so that it is easy accessible by the operator. See Section 2 for mounting dimensions.
Impulse Start Console (ISC)
The ISC should be mounted in a convenient location that is away from other electronic control devices. The ISC offers significantly reduced emissions compared to traditional high frequency, however, the high voltage pulse generated inside the unit may interfere with the operation of sensitive control electronics. The ISC is usually mounted on the gantry of the cutting machine or on the cutting table. See Section 2 for mounting dimensions.
5-Gang Manifold
The 5-gang manifold assembly must be mounted within 6 feet (1.8 m) of the torch. See Section 2 for mounting dimensions.
2-Gang Manifold
The 2-gang manifold assembly must be mounted to the torch. See Section 2 for mounting dimensions.
Torch
The torch must be installed on the positioner of an arc voltage control (height control) capable of maintaining the cutting arc voltage within 1 arc volt. The arc voltage must be adjustable in 1 arc volt increments. The positioner must be rigid to ensure cut quality and a torch collision sensor is highly recommended. See Section 2 for mounting dimensions. Cooling System The cooling system must be located within 8 feet (2.4 meters) of the plasma power supply. The surface on which the cooling system is located should have a grade of no greater than 10º to eliminate the risk of toppling over. See Section 2 for unit dimensions.
CNC Plasma Electrode Nozzle Shield Retaining Cap Swirl Ring Cutting For Use With LC105
The power supply must be cleaned as often as necessary to prevent the accumulation of metallic dust inside the unit. See Section 2 for unit dimensions.
Manual Gas Console (MGC)
The MGC should be mounted near the CNC controller so that it is easy accessible by the operator. See Section 2 for mounting dimensions.
Impulse Start Console (ISC)
The ISC should be mounted in a convenient location that is away from other electronic control devices. The ISC offers significantly reduced emissions compared to traditional high frequency, however, the high voltage pulse generated inside the unit may interfere with the operation of sensitive control electronics. The ISC is usually mounted on the gantry of the cutting machine or on the cutting table. See Section 2 for mounting dimensions.
5-Gang Manifold
The 5-gang manifold assembly must be mounted within 6 feet (1.8 m) of the torch. See Section 2 for mounting dimensions.
2-Gang Manifold
The 2-gang manifold assembly must be mounted to the torch. See Section 2 for mounting dimensions.
Torch
The torch must be installed on the positioner of an arc voltage control (height control) capable of maintaining the cutting arc voltage within 1 arc volt. The arc voltage must be adjustable in 1 arc volt increments. The positioner must be rigid to ensure cut quality and a torch collision sensor is highly recommended. See Section 2 for mounting dimensions. Cooling System The cooling system must be located within 8 feet (2.4 meters) of the plasma power supply. The surface on which the cooling system is located should have a grade of no greater than 10º to eliminate the risk of toppling over. See Section 2 for unit dimensions.
CNC Plasma Electrode Nozzle Shield Retaining Cap Swirl Ring Cutting For Use With LC105