| Quantity: | |
|---|---|
277131 277282 277286 277284 277151
Kailburn
Initial Inspection
All systems undergo full testing before being shipped from Kaliburn. In the unlikely event that one of the components is defective or missing, please contact Kaliburn so a replacement item can be sent. Also, Kaliburn has taken special care in packaging the system. If the system was damaged during shipment, file a claim with the shipping company, and then contact Kaliburn to order replacement parts.
Component Placement
Plasma Power Supply
The power supply should be lifted by a forklift, pallet jack or crane. In order to prevent damaging the power supply when lifting with a forklift or pallet jack, the forks should be of adequate length to protrude on the far side of the power supply. If lifting with a sling (lifting straps), ensure the following:
• Sling and material handling equipment must comply with local and national laws and regulations. The personnel involved in the move must be properly trained and qualified to use such equipment.
• All power supply covers must be securely installed.
• Two slings are required. Each sling should pass through all three (3) structural members on the bottom of the power supply. See sling access holes below.
• Lift slowly -not more than 8 in. (203 mm) high- to ensure even weight distribution.
• Move slowly to prevent uncontrollable acceleration/deceleration.
Kailburn Electrode 277131 277282 Nozzle 277284 277125 Shield 277150 277286 Retaining Cap 277151 Cutting Consumables
Initial Inspection
All systems undergo full testing before being shipped from Kaliburn. In the unlikely event that one of the components is defective or missing, please contact Kaliburn so a replacement item can be sent. Also, Kaliburn has taken special care in packaging the system. If the system was damaged during shipment, file a claim with the shipping company, and then contact Kaliburn to order replacement parts.
Component Placement
Plasma Power Supply
The power supply should be lifted by a forklift, pallet jack or crane. In order to prevent damaging the power supply when lifting with a forklift or pallet jack, the forks should be of adequate length to protrude on the far side of the power supply. If lifting with a sling (lifting straps), ensure the following:
• Sling and material handling equipment must comply with local and national laws and regulations. The personnel involved in the move must be properly trained and qualified to use such equipment.
• All power supply covers must be securely installed.
• Two slings are required. Each sling should pass through all three (3) structural members on the bottom of the power supply. See sling access holes below.
• Lift slowly -not more than 8 in. (203 mm) high- to ensure even weight distribution.
• Move slowly to prevent uncontrollable acceleration/deceleration.
Kailburn Electrode 277131 277282 Nozzle 277284 277125 Shield 277150 277286 Retaining Cap 277151 Cutting Consumables