Plasma Cutting Consumable F4020 Swirl Gas Cap .11.855.401.1628 For Kjellberg Torch

1.fan

- changeable filter pads made of metal (see maintenance)

2.tumbler switch "gas test / machine torch operation"

- upper position: Gas test ON

- for adjusting the plasma gas pressure

- for measuring the flow rate of plasma gas

- lower position: machine torch ready for cutting

- signal torch ON through remote control FB or X102 CNC

3. LED signal lamp white ON

- plasma torch ON

4.LED signal lamp yellow "error"

LED ON:

plasma cutting machine not ready for operation

error is defined through error codes (ER1 - ER....) on current display

5.current display

- indicates of the cutting current

6.potentiometer "cutting current"

- cutting current adjustment (35 - 100 A)

7.Red push button S3 "emergency stop", (reset button)

- activated: Plasma Cutting Machine OFF, (except control transformer and fan of control)

- unlocked: Plasma Cutting Machine ready for operation

8.Illuminated button green S2 "readiness for operation"

- activated:   - Plasma Cutting Machine ready for operatio  

- power ON for main transformer, cooling unit, fan and controls

- signal lamp ON:  - Plasma Cutting Machine ready for operation

9.Key switch S1 "Mains ON"

- Position 0: voltage to control transformer and fan of control OFF

- Position 1: voltage to control transformer and fan of control ON, PGC ON

Plasma Cutting Consumable F4020 Swirl Gas Cap .11.855.401.1628 For Kjellberg Torch