Plasma Cutting Consumable G121C Swirl Ring.11.848.421.145C For Kjellberg Torch

The plasma torches are generally to be connected to the respective plasma torch connection unit PBA.

The plasma torch has to be fastened to the support of the guiding system by using an adequate insulation.

A special torch holder is available from Kjellberg Finsterwalde.

The plasma torches are connected to the connectors on and in the PBA. The following connections shall be

established:

· Coolant outlet

· Coolant inlet

· Control gas

Lead the plasma gas hoses and the swirl gas hoses through the corresponding openings of side wall on the

outside and connect them to the marked quick couplings. Unscrew the sleeve nut to this, clip the hose to the

plug nipple and fasten the nut on thightly.

· Plasma gases

· Swirl gas

Relieve the hose assembly with green clip to train.

The position numbers indicated in the sections below, e.g. (01.08), refer to the spare parts drawings above.

You will find these spare parts drawings in the appendix „Spare parts lists".

In order to increase the lifetime of the o-rings we recommend the occasional use of an exclusively oxygen-

suitable lubricant:

· Please apply the lubricant only to the o-rings marked with # in the following picture!

· Please wet the o-rings only slightly with the lubricant!

· Please make sure that no lubricant enters the nipples and borings!

Plasma Cutting Consumable  G121C Swirl Ring.11.848.421.145C For Kjellberg Torch