| Quantity: | |
|---|---|
S2010
Kjellberg
The maximum cutting power of 16.6 kVA conveyed to the workpiece according to the principle of direct
discharge, allows the cutting of electrically conductive materials up to a maximum thickness of 40 mm,
depending on the type of material.
Constructional steels, high-alloyed steels, nonferrous metals (e.g. aluminium), and special alloys can be cut.
Air is used as plasma gas.5374193_19.doc x @ 281857 @ @ 1
The plasma torch Flash 101 G/L can be used for flying cutting start (edge start) and hole piercing._1201522878616_19.doc x @ 3242 @ @ 1
Cutting is possible in all positions and applicable for straight cutting (line or profile) and bevel cutting as well,
on plates, sheet metal, tubes and pipes, forced and forged parts, piled plates, casted parts and scarp metal.
Because of the variable current setting the cutting power easily can be adapted to the process requirements.
The direct transferred plasma arc enables the marking of all electrically conductive materials with no regard
to thickness and quality (Mild steels, high alloyed steels and special alloys). Aluminium is less well suitable
due to its specific material properties for marking.
The marking process is applicable at all kind of material, like sheet metal, tubes, profiles, forged and casted
parts, laminated sheet packages, scrap metal products and cast iron products.
The marking current is stepless adjustable to conform optimal to the marking requirements.
The plasma marking is automatically detected at a current setting of less than 125 A.
Plasma Cutting Consumable S2010 Nozzle.11.843.021.410 For Kjellberg Torch
The maximum cutting power of 16.6 kVA conveyed to the workpiece according to the principle of direct
discharge, allows the cutting of electrically conductive materials up to a maximum thickness of 40 mm,
depending on the type of material.
Constructional steels, high-alloyed steels, nonferrous metals (e.g. aluminium), and special alloys can be cut.
Air is used as plasma gas.5374193_19.doc x @ 281857 @ @ 1
The plasma torch Flash 101 G/L can be used for flying cutting start (edge start) and hole piercing._1201522878616_19.doc x @ 3242 @ @ 1
Cutting is possible in all positions and applicable for straight cutting (line or profile) and bevel cutting as well,
on plates, sheet metal, tubes and pipes, forced and forged parts, piled plates, casted parts and scarp metal.
Because of the variable current setting the cutting power easily can be adapted to the process requirements.
The direct transferred plasma arc enables the marking of all electrically conductive materials with no regard
to thickness and quality (Mild steels, high alloyed steels and special alloys). Aluminium is less well suitable
due to its specific material properties for marking.
The marking process is applicable at all kind of material, like sheet metal, tubes, profiles, forged and casted
parts, laminated sheet packages, scrap metal products and cast iron products.
The marking current is stepless adjustable to conform optimal to the marking requirements.
The plasma marking is automatically detected at a current setting of less than 125 A.
Plasma Cutting Consumable S2010 Nozzle.11.843.021.410 For Kjellberg Torch