| Quantity: | |
|---|---|
228295
Hypertherm
Torch connections Connect the torch to the torch lead assembly
1. Uncoil the first 2 meters (6.5 ft) of the leads on a flat surface.
2. Hold the torch assembly in place with the spanner wrench (104269) and remove the mounting sleeve from the torch assembly.
3. Push back the braided cover and slide the sleeve over the leads. Align the torch with the hoses in the lead assembly. The hoses must not be twisted. They are taped together to help prevent twisting.
4. Connect the coolant IN hose (green) to the torch.
5. Connect the pilot arc lead. Note: Be careful not to damage or remove the small slotted metal band at the end of the pilot arc cable.
5a. Pull the sleeve back until the connector is exposed.
5b. Screw the connector onto the pilot arc connection from the torch. Tighten by hand until it is firmly seated.
5c. Slide the sleeve forward until it clicks into place.
6. Connect the plasma-gas vent hose.
7. Connect the coolant return hose (red).
8. Connect the plasma gas hose.
9. Connect the shield gas hose.
10. Slide the torch sleeve over connections and screw it onto the torch body.
11. Slide the braided cover up to the torch sleeve. Make sure that the plasma, shield and vent hoses are routed through the hole in the braided cover. Loosen the hose clamp on the braided cover, slide the braided cover and clamp over the sleeve and tighten the clamp
Part number | ||
Lead length | 6' gas | 8' gas |
2 m (6') | 228291 | 228410 |
3 m (10') | 228292 | 228411 |
Plasma Cutting Torch Cable Leads 228295 For HPR Series
Torch connections Connect the torch to the torch lead assembly
1. Uncoil the first 2 meters (6.5 ft) of the leads on a flat surface.
2. Hold the torch assembly in place with the spanner wrench (104269) and remove the mounting sleeve from the torch assembly.
3. Push back the braided cover and slide the sleeve over the leads. Align the torch with the hoses in the lead assembly. The hoses must not be twisted. They are taped together to help prevent twisting.
4. Connect the coolant IN hose (green) to the torch.
5. Connect the pilot arc lead. Note: Be careful not to damage or remove the small slotted metal band at the end of the pilot arc cable.
5a. Pull the sleeve back until the connector is exposed.
5b. Screw the connector onto the pilot arc connection from the torch. Tighten by hand until it is firmly seated.
5c. Slide the sleeve forward until it clicks into place.
6. Connect the plasma-gas vent hose.
7. Connect the coolant return hose (red).
8. Connect the plasma gas hose.
9. Connect the shield gas hose.
10. Slide the torch sleeve over connections and screw it onto the torch body.
11. Slide the braided cover up to the torch sleeve. Make sure that the plasma, shield and vent hoses are routed through the hole in the braided cover. Loosen the hose clamp on the braided cover, slide the braided cover and clamp over the sleeve and tighten the clamp
Part number | ||
Lead length | 6' gas | 8' gas |
2 m (6') | 228291 | 228410 |
3 m (10') | 228292 | 228411 |
Plasma Cutting Torch Cable Leads 228295 For HPR Series