| Quantity: | |
|---|---|
9-8215 9-8232 9-8208 9-8210 9-8212 9-8253 9-8256 9-8238 9-8239 9-8245
Thermal Dynamics
1. Unscrew and remove the shield cup from the torch.
Slag built up on the shield cup that cannot be removed may effect the performance of the system.
2. Inspect the cup for damage. Wipe it clean or replace if damaged.
3. On torches with a shield cup body and a shield cap or deflector, ensure that the cap or deflector is threaded snugly against the shield cup body. In shielded drag cutting operations (only), there may be an O-Ring between the shield cup body and drag shield cap. Do not lubricate the O-Ring.
4. Remove the tip. Check for excessive wear (indicated by an elongated or oversized orifice). Clean or replace the tip if necessary.
5. Remove the starter cartridge. Check for ex-cessive wear, plugged gas holes, or discol-oration. Check the lower end fitting for free motion. Replace if necessary.
6. Pull the Electrode straight out of the Torch Head. Check the face of the electrode for excessive wear. Refer to the following figure.
7. Reinstall the Electrode by pushing it straight into the torch head until it clicks.
8. Reinstall the desired starter cartridge and tip into the torch head.
9. Hand tighten the shield cup until it is seated on the torch head. If resistance is felt when installing the cup, check the threads before proceeding.
This completes the parts replacement procedures.
Plasma Electrode Nozzle Shield Cap 9-8235 9-8256 9-8226 9-8244 9-8227 9-8215 For SL60SL100
1. Unscrew and remove the shield cup from the torch.
Slag built up on the shield cup that cannot be removed may effect the performance of the system.
2. Inspect the cup for damage. Wipe it clean or replace if damaged.
3. On torches with a shield cup body and a shield cap or deflector, ensure that the cap or deflector is threaded snugly against the shield cup body. In shielded drag cutting operations (only), there may be an O-Ring between the shield cup body and drag shield cap. Do not lubricate the O-Ring.
4. Remove the tip. Check for excessive wear (indicated by an elongated or oversized orifice). Clean or replace the tip if necessary.
5. Remove the starter cartridge. Check for ex-cessive wear, plugged gas holes, or discol-oration. Check the lower end fitting for free motion. Replace if necessary.
6. Pull the Electrode straight out of the Torch Head. Check the face of the electrode for excessive wear. Refer to the following figure.
7. Reinstall the Electrode by pushing it straight into the torch head until it clicks.
8. Reinstall the desired starter cartridge and tip into the torch head.
9. Hand tighten the shield cup until it is seated on the torch head. If resistance is felt when installing the cup, check the threads before proceeding.
This completes the parts replacement procedures.
Plasma Electrode Nozzle Shield Cap 9-8235 9-8256 9-8226 9-8244 9-8227 9-8215 For SL60SL100